This machine is used for grinding herbs in traditional method with the help of electric motor. This mechine is supplied with motor.

This machine is used for grinding materials soaked in water . Machine is supplied without motor. Single stone and double stone grinders are available.

PILOT CUBICAL CONTROL PANELS  are designed to meet the total electrical control requirements of small to large industries drawing power from 415 volts 3 phase lines.
ONE SINGLE PANEL accommodates all the switchgear required to run a unit. The incomer fuse switch, energy meters, earth leakage protection equipments, volt meters and ammeters, different starters, power factor improving capacitors etc; are prefixed in suitable compartments as per the customer requirement and all the required internal wiring done at our factory. This is a substitute for the widely practiced  system of separately purchasing and fixing of all individual components on to a vertical flat sheet steel board. Pilot cubical control panels greatly reduce cost on site wiring, gives a neat appearance to your work place and saves on floor space.
QUALITY MATERIAL AND WORK  join hands to make pilot cubical control panels. You do not have to rely on semi skilled workmanship and spurious components. Qualified and trained workmen make use of components procured from the inherent safety of the integrated panel systems. We take special care to ensure the quality of work and material. The panel is constructed with quality sheet steel of sufficient thickness and is well painted 
EASY AND EFFECTIVE MAINTENANCE of the system is possible since modules can be taken out individually. Sufficient over rating is incorporated in the design to cater for most abnormal conditions. Spare empty modules can be included in the panel to provide for future expansion. Modules are identified using name tags. Wherever necessary cables are also marked appropriately.
REMOTE CONTROL  and metering of motors is easy with this item. Ammeters to judge load current of pulverising equipments can be placed near the machine.  Push buttons can be conveniently located to comply with the regulation, which stipulates maximum distance between the motor and off button to be 3 meters. All this can be done with only 1.5 SQ. MM control wires.